Dometic RM7655L User Manual download pdf (Page 22)

Installation recess

The refrigerator must be installed draught-free in a recess (see 6.2).

The measurements of the recess are given in the table below.

Push the appliance far enough into the recess until the front edge of the refrigerator

casing is flush with the front of the recess. Allow a gap of 10-20 mm between the back

wall of the recess and the refrigeration unit. The floor of the recess must be level, allo-

wing the appliance to be pushed easily into its correct position. The floor must be sub-

stantial enough to bear the weight of the appliance (no hollow space underneath).

Ensure that the refrigerator is installed level in the recess.

Recess measurements:

Securing the refrigerator

In the sidewalls of the refrigerator, there are four plastic

sleeves with screws for securing the refrigerator. The

sidewalls or rails attached for securing the refrigerator

must be designed in such a way that the screws will

remain firmly in place even when under increased load

(while the vehicle is moving).

Always insert screws through the sleeves provided;

otherwise, structural parts embedded in the foam,

such as cables, etc., may be damaged.

Once the refrigerator is in its final position, secure the

screws into the wall of the recess.

The screws must penetrate

through the sheet metal

casing of the refrigerator.

6.5

6.6

RM 7601 / RM 7605 1248 mm 530 mm 510 mm

RM 7651 / RM 7655 1248 mm 530 mm 510 mm

Model Hight H Width W Depth T

Width of recess = W

Stopper strips for example are affixed

in the installation bay, at the sides, at

the bottom and at the top and are fitted

with flexible sealant strips

Affix strip to side wall.

Seal i.e.V seal.

plan view

Width of recess = W

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

No comments

Dometic RM7655L User Manual Page 22