Dometic RH449LDFS User Manual download pdf (Page 6)

Figure 4.

During installation, please ensure the

mains plug is accessible at all times.

4.1.2. Free-standing version

This version is supposed to be used free-standing.

Cooling unit covers protect the hot parts of the cooling

units. Feet ensure sufficient ventilation.

5. Using the appliance

To start the refrigerator connect the plug to the socket

outlet. The empty refrigerator needs about 6-7 hours

at normal ambient temperature to reach the proper

temperature in the storage compartment.

5.1. Initial operation

The device must be plugged into a properly earthed

socket.

The miniBar starts automatically with a self-test. If

the electronics do not detect any fault, the

refrigerator starts to cool down. If a fault is

detected, the refrigerator stops cooling. If this

occurs, please consult your authorised Customer

Service.

5.2. Temperature regulation

The miniBar is fitted with a fully automatic electronic

temperature regulator. It is not needed to set the

temperature of the storage compartment manually.

5.3. Cooling unit control (CUC)

The electronic checks the function after every

defrosting period (every 24 hours) by measuring the

evaporator temperature drop. If it registers a problem

the refrigerator will shut down and stops cooling. If this

happens you should check whether the refrigerator

has been overloaded, that the door was properly

closed, that the cooling unit ventilation is correct and

that the refrigerator is levelled. After checking, unplug

the refrigerator at least for 10 seconds and plug in

again. This resets the unit and it will function again. If

no sign of cooling there is a problem and you should

then contact Dometic service.

miniCool

min. 60 mm

Ventilation grille

Air in

miniCool

Air in

Air out

6. Ice cubes

Fill the ice tray up to 4/5 with drinking water, cover

with the lid and place the closed ice tray on the ice-

tray shelf. Wipe off any excess water to prevent the

ice tray from freezing to the surface.

To remove the cubes from the ice tray, hold it under

running water. Remove the lid with the ice cubes

from the ice tray and the ice cubes can now be

taken out easily.

7. Useful suggestion

Do not overfill the appliance. If possible, always

store pre-cooled food and/or drinks. It is advisable

to leave some space between the products in the

cabinet to ensure efficient and even cooling. If the

shelves are packed too tightly there may be

unacceptable temperature variations.

8. Defrosting, cleaning and

maintenance

Frost will gradually form on the cooling plate and it

must not be allowed to become too thick since it

restricts the cooling.

This miniBar is fitted with a fully automatic

electronic temperature regulator.

The frost will melt and the defrost water will run

through the drain tube from the drip channel into an

evaporating vessel located at the bottom rear of the

refrigerator. (Fig. 5) The defrost water will evaporate

automatically into the circulating air and the vessel

will not need emptying.

Figure 5.

To switch off the unit, disconnect the refrigerator

from the electricity supply and leave the cabinet

door open. After defrosting the cabinet interior

should be wiped out with a clean, damp cloth.

8.1. Automatic defrost function

The first defrosting phase commences 39 hours

after the start and lasts for two hours.

After this, the device operates for 22 hours at a

time, followed by a defrosting period of 2 hours.

8.2. Interior light (fig. 6.)

Two light-emitting diodes (A) on an electronic PCB

illuminate the cooling compartment when the door

is opened.

miniBar

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments

Dometic RH449LDFS User Manual Page 6

Comments to this Manuals

Related products and manuals for Fridges Dometic RH449LDFS