Dometic 3312024 series Specifications download pdf (Page 8)

8

b. Choose the shortest, most direct route from

the 14-1/4" x 14-1/4" (±1/8") opening to the

selected CCC 2 thermostat location. Leave

6" of cable extending through the wall.

c. Route the communication cable through the

2" diameter hole in the wall required for the

thermostat. See FIG. 8.

d. Optional Indoor Temperature Sensor

i. Refer to the instructions provided with

the indoor temperature sensor for details

of installation.

e. CCC 2 Thermostat Installation

CCC 2 Thermostat

(Rear View)

Wall

FIG. 8

CCC 2 Thermostat

Disengage Tab

FIG. 9

4 Conductor

Communication Cable

FIG. 10

H. Placing The Unit On The Roof

1. Remove the unit from the carton and discard car-

ton.

2. Place the unit on the roof.

3. Lift and place the unit over the prepared opening

using the gasket on the unit as a guide. See FIG.

11.

This unit weighs approximately 100 pounds.

To prevent back injury, use a mechanical hoist

to place unit on roof.

i. Carefully separate the thermostat base

plate from the thermostat cover. Insert

a small screw driver into the slot on bot-

tom of thermostat and disengage the tab.

See FIG. 9.

ii. Insert the 4 conductor communication

cable through the hole in base plate.

Align thermostat base plate with hole in

wall. Make sure base plate is level and

attach base plate to wall using the 4 sup-

plied screws.

iii. Insert the 4 conductor communication

cable connector (RJ-11-6C4P) into the

connector on the back of the thermostat.

See FIG. 10.

iv. Align the thermostat with the back plate

and snap into position.

G. Thermostat, Indoor Temperature Sensor,

& Thermostat Communication Cable In-

stallation

1. CCC 2 Thermostat

a. The previously run communication cable (4

conductor telephone cable) must be termi-

nated with two (2) RJ-11-6C4P telephone

connectors. Refer to the crimp tool manufac-

turer for crimping instructions. See FIG. 6 &

7.

Important: RJ-11-6C4P connectors must be in-

stalled as shown in FIG. 6 & 7.

FIG. 6

Black

Red

Green

Yellow

Black

Red

Green

Yellow

Flat Four Conductor

Communication Cable

RJ-11-6C4P Connector

Pin 1

FIG. 7

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments