Dometic RH131D User Manual download pdf (Page 7)

and place them in the open hinge holes in the

housing. Place the bottom righthand hinge in the top

left of the door and the top righthand hinge in the

bottom left of the door and hang the door on its hinges

in the open cover cap holes in the housing. Secure

the hinges and cover caps with the 8 screws.

Check that the door closes easily and is sealed

properly.

11. Replacing the decorative door

panel (Fig. 8-10)

Remove the two screws (1) from the upper hinge of

the door.

Figure 7

Figure 8

Figure 9.

Figure 10.

Pull the door together with the hinge away from the

housing and up off the lower hinge bolt (2-3).

Remove screws (4) and pull off the frame edge

(5).

Slide the decorative panel (6) out of the door

frame and insert the new panel (7), so that the

upper edge of the panel runs exactly parallel to the

upper edge of the frame. A new panel can be

inserted more easily into the upper edge of the

frame when the two corners are cut off by approx.

5 x 5mm (8). Put the frame edge (5) back in place

and secure with screws.

12. Changing the feet (if available)

Should you wish to install your miniBar, you will not

need the 40-mm feet. After having removed the 40-

mm feet, you can then re-attach the 12-mm feet,

located inside the 40-mm feet, to the front and rear

fixing points. The 40-mm feet and the 4 remaining

screws should be retained for future use.

Place the door on the lower hinge (9), slot the upper

hinge into the opening, press together with the door

against the housing and secure with the two screws

(11).

Figure 11

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Dometic RH131D User Manual Page 7