Dometic RM2620 User Manual download pdf (Page 14)

INSTRUCTIONS FOR MOUNTING

THE DOOR PANEL

The refrigerator is normally delivered without door panels.

Before starting the mounting work, check that the panel

dimensions are in compliance with those given in the

table and the instructions are read thoroughly.

When mounting the panel, proceed as follows:

A. Open the door 90 degrees.

On new refrigerators, the decoration strips are

taped inside the door; if installed on the door,

remove the door decoration strip (2) by removing

its two screws (1).

B. Insert one vertical edges into the groove of the door

frame (3).

C. Bend the panel gently so that the free side of the

panel can be slipped into the corresponding groove

of the door frame (4). Slide the panel down into the

groove of the bottom frame (5).

D. Between the upper edge of the panel and the door

frame there is a gap which should be covered by

the decoration strip.

E. Put the decoration strip across the door so that the

gap is covered and push it upward (6). The tabs on

the inside of the strip should fit behind the flange of

the door frame. Secure the decoration strip with the

two screws removed in Step A (1).

PANEL DIMENSIONS

MAX. THICKNESS 5/32" (4 mm)

REFR. MODELS HEIGHT WIDTH

TYPE MAX. MIN. MAX. MIN.

RM 2620

upper mm 306 304 515 513

inch 12-3/64 11-31/32 20-9/32 20-13/64

lower mm 819 817 515 513

inch 32-1/4 32-5/32 20-9/32 20-13/64

RM 2820

upper mm 378 376 563 561

inch 14-7/8 14-51/64 22-11/64 22-3/32

lower mm 897 895 563 561

inch 35-5/16 35-15/64 22-11/64 22-3/32

1 2 ... 9 10 11 12 13 14 15 16

No comments

Dometic RM2620 User Manual Page 14