Dometic SN01072121 User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
16
HTS COMPONENTS
TankSaver™ Vacuum
Relief Valve
SeaLand’s TankSaver™
vacuum relief valve prevents
damage due to holding tank
implosion from dockside
pumps that operate at very
high levels of vacuum. The
TankSaver valve opens auto-
matically under vacuum, but
remains sealed regardless of shock-loading or
vibrations.
TankWatch
®
4 Level Monitor and Micro-Float
Switches
Includes four tank level indicator lights – Empty, Low,
Mid and Full, and international symbology of four tank
levels. One light is always on. Reliable micro-float
switches are installed in holding tank. No electrical
components come in contact with waste or water. Op-
erates on 12 or 24-volt DC. Uses only .017 amps at
13-volts. Micro-float switches are installed in all HTS
tanks either as a unit (with a TankWatch cap) or as
individual Empty, Mid and Full probes.
SaniPump™ Overboard Waste Discharge Pump*
This T-series discharge pump can run dry without harm
and draws just 6 amps at 12 VDC. Delivers flow rate
of just over 3.9 gallons per minute (14.7 liters per
minute). Emptying the tank of the 10HTS takes about
three minutes, and for the 42 HTS about 11 minutes.
The discharge pump is connected to a through-hull
fitting. Check Marine Sanitation Regulations for infor-
mation on areas where discharge is allowed.
SaniGard™ Holding Tank Vent Filter*
The vent filter stops odors that escape from the hold-
ing tank vent. It contains odor-removing filter media
to keep your boat smelling clean and pleasant. Each
cartridge is good for an entire season and is easily
replaced for a fresh start. The vent filter includes
mounting brackets and hose adapters, and is avail-
able with either 5/8-inch (16mm) or 1½-inch (38mm)
hose fittings.
* Not available on all HTS models.
VacuFlush Shutdown Relay
To prevent overfilling of a holding tank, a shutdown re-
lay is supplied as standard with 10HTS, 18HTS, and
35HTS models. The relay is optional (p/n 600341292 -
12VDC, p/n 600342490 - 24VDC) on standard 28HTS,
40HTS, and 42HTS models. The relay shuts off power
to the vacuum generator when the holding tank reaches
the "Full" level, preventing further flushing of the toilet.
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments