Dometic WMD1050 User Manual download pdf (Page 14)

What to do if…

Certain problems are due to lack of simple

maintenance or oversights, which can be

solved easily without calling out an engi-

neer. Before contacting your local Service

Centre, please carry out the checks listed

below.

During machine operation it is possible that

the End pilot light blinks to indicate that the

machine is not working:

• 1 flash: problem with the water supply.

• 2 flashes: problem with the water drain-

ing.

• 4 flashes: door open.

Once the problem has been eliminated,

press the button START to restart the pro-

gramme. If after all checks, the problem

persists, contact your local Service Centre.

Problem Possible cause/Solution

The machine does not start:

The door has not been closed.

• Close the door firmly.

The plug is not properly inserted in the power socket.

• Insert the plug into the power socket.

There is no power at the socket.

• Please check your domestic electrical installation.

The main fuse has blown.

• Replace the fuse.

The selector dial is not correctly positioned and the button Start

has not been pressed.

• Please turn the selector dial and press the button Start again.

The machine does not fill:

The water tap is closed.

• Open the water tap.

The inlet hose is squashed or kinked.

• Check the inlet hose connection.

The filter in the inlet hose is blocked.

• Clean the water inlet hose filter.

The door is not properly closed.

• Close the door firmly.

The machine fills then emp-

ties immediately:

The end of the drain hose is too low.

• Refer to relevant paragraph in «Installation» chapter.

The machine does not

empty and/or does not

spin:

The drain hose is squashed or kinked.

• Check the drain hose connection.

An option or a programme that ends with the water still in the tub

or that eliminates all the spinning phases has been selected.

• Select the draining or spinning programme.

The laundry is not evenly distributed in the drum.

• Redistribute the laundry.

There is water on the floor:

Too much detergent or unsuitable detergent (creates too much

foam) has been used.

• Reduce the detergent quantity or use another one.

Check whether there are any leaks from one of the inlet hose fit-

tings. It is not always easy to see this as the water runs down the

hose; check to see if it is damp.

• Check the water inlet hose connection.

The drain or inlet hose is damaged.

• Change it with a new one.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments

Dometic WMD1050 User Manual Page 14

Comments to this Manuals

Related products and manuals for Washing machines Dometic WMD1050