Dometic CS200VS User Manual download pdf (Page 3)

1. Remove the transport pallet on which your wine

cellar rests.

Installation

Please follow these installation instructions:

For best performance, air needs to circulate freely

over the cooling unit behind the wine cellar. The free-

standing design of the cellar means that it should

stand at least 25 mm from the rear and side walls.

Allow a clearance of at least 100 mm above the wine

cellar.

Adjust the feet of the wine cellar so that it stands in a

vertical position in both directions. Use a spirit level if

necessary. FIG.1

2. IMPORTANT ! Adjust the feet to allow a 30mm

clearance under the wine cellar

3. Attach the distance bar using the two screws at the

top back on each side of the cellar. The rod ensures

the correct distance to the wall behind. FIG 2,FIG4.

4. For optimum performance, please place your wine

cellar far away from any source of heat

(radiator,cooker or intence sunlight) .

5.Check that the charcoal filter is in place at the top

left corner inside the wine cellar.

Please note that it must be possible to open the

wine cellar door at least 90° to allow the sliding

shelves to be pulled out.

6. Fit the door handle to the door. The door frame has

pre-drilled holes on its side(s). FIG 3

* IMPORTANT WARNING !

7. Attach the driptray on the back as shown on the

pictures FIG 5a , 5b , 5c. on side 5. The screws are

already attached at the back.

FIG 2

FIG 3

Wall

30 mm

FIG. 1

Wall

Rear

Distance bar

1 2 3 4 5 6 7 8

No comments

Dometic CS200VS User Manual Page 3