TROUBLESHOOTING & DIAGNOSTIC TEST
This section is intended for service personnel.
To perform a diagnostic test:
Turn off the refrigerator. (Press the ON/OFF button.)
Press and hold the TEMP. SET button and then,
Release the TEMP. SET button. Press it again
to toggle the list of functions step by step.
For information about test functions and indications, refer to the following table.
The messages are displayed fl ashing - alternating between “Test indication” and “Test result indication”.
“Unfi ltered temperature in F”
Press the lamp switch. The lamp should still be on.
AC heater off, AC not available
Igniter and valve off, gas hardware fault
Igniter off and valve on, fl ame detected
Igniter and valve off, gas problem (check gas)
(If fl ame is not ignited within 45 seconds)
Comments to this Manuals