Dometic RM4605 User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
8
Securing the refrigerator
After the refrigerator is put in place, (insuring a combus-
tion seal at the front frame), the refrigerator is to be se-
cured in the enclosure with six screws. The screws have
to be installed in the following order:
STEP 1: Two screws installed through the front base,
which includes the lower front strip installation.
The refrigerator is provided with a lower front strip (sipped
as a loose part). The front strip is to be attached after the
refrigerator is set into the cutout opening.
1. Install the lower front strip by sliding it under the bot-
tom hinge plate, as shown in FIG. 3. The hinge plate
can be on the right or left side depending on the door
swing.
2. Once the lower front strip is slipped under the hinge,
the part is possible to swing into place as shown in
FIG. 4.
3. Secure the refrigerator and the lower front strip with
two screws:
One screw through the hinge, and on the opposite
side one screw through the lower front strip. (FIG. 4).
FIG. 6
STEP 2: Two screws installed in the top frame.
The top decoration panel must be removed from the re-
frigerator before the screws can be installed.
Open the door and gently push the tabs out of the hole
in the hinge with a flat blade screwdriver, (both sides).
See FIG. 5.
Carefully tilt the top decoration panel and lift up to re-
move from top frame. Be careful not to damage the cir-
cuit board and wires.
2
1
FIG. 3
3
FIG. 4
FIG. 5
1
2
Install the two screws in the top frame, the holes are
accessible from underneath.
Seal the opening for the screws with aluminium tape.
Replace the top decoration panel. Be careful not to pinch
the wires behind the panel.
Make sure the tabs snap back into the holes in the hinge
plate.
STEP 3: Two screws installed in the rear base.
See FIG. 6
Failure to follow the sequence in securing the refrigerator
in the enclosure can cause leakage between the frame
and cabinet.
Any space between the counter, storage area or ceiling
and top of the refrigerator greater than 40 mm should be
blocked. The heat produced at the rear of the refrigera-
tor will become trapped in this space, making the top of
the refrigerator hot and reduce the efficiency of the re-
frigerator.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments