Dometic Elite RM7732 User Manual download pdf (Page 9)

OFF

AUTO

AC GAS

CHECK COLD 1 2 3 4 5 COLDEST

3.3.

STST

ARAR

-UP INSTR-UP INSTR

-UP INSTR

UCTIONSUCTIONS

UCTIONS

Before starting the refrigerator, check that all the manual

gas valves are in the ON position. DO NOT forget the

manual shutoff valve on the rear of the refrigerator. See

FIG. 12.

This refrigerator is equipped with a control system, which

can automatically select the most suitable energy source

which is available, either AC or LP gas operation. The

system can be set by the user to be fully automatic, or if

desired, LP gas only.

1. A 12 volt DC supply must be available for the electronic

control to function. The refrigerator controls will work

down to 9.6 volts DC.

2. Press the main power ON/OFF button (1) to the DOWN

position.

3. Press the TEMPERATURE SELECTOR button (3) until

the lamp at the desired setting is illuminated.

2-WAY DISPLAY PANEL2-WAY DISPLAY PANEL

2-WAY DISPLAY PANEL

A. AUTO MODE

Press the AUTO mode selector button (2) to the DOWN

position. If 120 volts AC is available, the AC mode

indicator lamp (A) will illuminate indicating AC operation.

If 120 volts AC is not available, the GAS mode indicator

lamp (C) will illuminate and the control system will

automatically switch to GAS operation.

If the CHECK indicator lamp (D) illuminates and the

GAS mode indicator lamp (C) is OFF, the controls have

failed to ignite the burner in the GAS mode. GAS

operation may be reset by pressing the main power ON/

OFF button (1) to the OFF then ON position. (See GAS

MODE.

Press the TEMPERATURE SELECTOR button (3) until

the lamp at the desired position is illuminated.

B. GAS MODE

Move the AUTO mode selector button (2) to the UP

position. The GAS mode indicator lamp (C) will illumi-

nate. After 45 seconds the burner should be ignited and

operating normally.

On the initial refrigerator start-up, it may take longer

than 45 seconds to allow air to be purged from the gas

line. If the gas does not ignite within 45 seconds, the

CHECK indicator lamp (D) will illuminate and the GAS

mode indicator lamp (C) will go off. To reset when the

CHECK indicator lamp (D) is illuminated, press main

power ON/OFF button (1) to the OFF then ON position.

NOTE: DO NOT continue to reset GAS operation if

the CHECK indicator lamp continues to be illumi-

nated after several tries.

Press the TEMPERATURE SELECTOR button (3) until

the lamp (E) at the desired position is illuminated.

C. THERMOSTAT

The thermostat on the refrigerator controls both the gas

and electric operation, thereby eliminating the necessity

of resetting each time a different energy source is

employed.

After the initial start-up, the thermostat should be moved

from "COLDEST" to the desired temperature setting is

usually about mid-setting.

D. TO SHUT OFF THE REFRIGERATOR

The refrigerator may be shut off while in any mode of

operation by pressing the main power ON/OFF button

(1) to the UP (OFF) position. This shuts off DC power to

the refrigerator, including the interior light; however, the

climate control will remain on. See Item 5, Step G on

Page 10.

4.4.

DESCRIPTION OF OPERADESCRIPTION OF OPERA

DESCRIPTION OF OPERA

TINGTING

TING

MODESMODES

MODES

A. AUTO MODE

When operating in the AUTO mode, the AUTO mode

indicator lamp (B) will illuminate. The control system will

automatically select between AC and GAS operation

with AC having priority over GAS. Either the AC indica-

tor lamp (A) or the GAS indicator lamp (C) will illuminate

depending on the energy source selected by the control

system. If the control system is operating with AC

energy and it then becomes unavailable, the system will

automatically switch to GAS. As soon as AC becomes

available again, the control will switch back to AC

regardless of the status of GAS operation.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Dometic Elite RM7732 User Manual Page 9

Comments to this Manuals

Related products and manuals for Refrigerators Dometic Elite RM7732