Dometic CA1000 User Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 157
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
31
Dometic CA1000 Installation
7.3.1 Start and end configuration mode
The adjustable parameters can be altered in edit mode:
With the system switched off, press the ON/OFF button (fig. e 1,
page 6).
With the system switched on, hold down the ON/OFF button for at
least 2 seconds.
Then hold down the Mode button (fig. e 4, page 6) for at least 2 sec-
onds.
Let go of the ON/OFF button.
The Compressor LED (fig. e 3, page 6) flashes.
Let go of the Mode button.
You are now in configuration mode.
The first digit of the display (fig. e 5, page 6) shows the menu level
and the second and third show the parameter which can be set – e.g.
1.17 for menu level 1 and a set value of 17 °C.
I
Note
If you make no entry on the control panel for 60 seconds, the system quits
configuration mode.
Press the ON/OFF button to quit configuration mode.
7.3.2 Menu level 1: Set temperature
The system always starts with a defined value for the room temperature.
This parameter can be configured between 17 and 30 °C:
Start configuration mode (see chapter “Start and end configuration
mode” on page 31).
The first digit of the display (fig. e 5, page 6) shows the menu level
and the second and third show the parameter which can be set.
Press the Mode button (fig. e 4, page 6) to change the parameter.
Use the
+
and
buttons (
fig. e 6 und 7, page 6
)
to select the temper-
ature (in °C) with which the system starts.
The digits in the display flash until the parameter you enter is con-
firmed.
Press the Mode button (fig. e 4, page 6) to confirm your entry.
The set value is saved and is then used when the system is restarted.
You are now in menu level 1 and can use the + and - buttons to switch
between menu levels.
_IA_CA1000.book Seite 31 Donnerstag, 12. Juni 2008 11:53 11
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 156 157

Comments to this Manuals

No comments