Dometic EA3120 User Manual download pdf (Page 6)

9. Reversing the door hang, (Fig. 6)

Lay the appliance on its back. Remove the 8

screws (1). Remove the door, together with the two

hinges (2), from the housing.

Remove the two cover caps (3) from the housing and

place them in the open hinge holes in the housing.

Place the bottom righthand hinge in the top left of the

door and the top righthand hinge in the bottom left of

the door and hang the door on its hinges in the open

cover cap holes in the housing. Secure the hinges

and cover caps with the 8 screws.

Check that the door closes easily and is sealed

properly.

Figure 6.

10. Replacing the decorative

door panel, (Fig. 7-9)

Remove the two screws (1) from the upper hinge of

the door.

Pull the door together with the hinge away from the

housing and up off the lower hinge bolt (2-3).

Figure 7.

Remove screws (4) and pull off the frame edge (5).

Slide the decorative panel (6) out of the door frame

and insert the new panel (7), so that the upper

edge of the panel runs exactly parallel to the upper

edge of the frame. A new panel can be inserted

more easily into the upper edge of the frame when

the two corners are cut off by approx. 5 x 5 mm (8).

Put the frame edge (5) back in place and secure

with screws.

Figure 8.

warmer temperature. The effect of any adjustment can

be checked by means of the thermometer after

leaving the refrigerator operating for a further period to

settle down again.

Figure 4.

6. Useful suggestion

Do not overfill the appliance. Put warm foods and drinks

in the appliance only when they have cooled down to

room temperature. It is advisable to leave some space

between the products in the cabinet to ensure efficient

and even cooling. If the shelves are packed too tightly

there may be unacceptable temperature variations.

7. Defrosting, cleaning and

maintenance

Frost will gradually form on the cooling surfaces and it

must not be allowed to become too thick since it acts

as an insulator and interferes with the cooling.

This frost-formation is kept back by the FUZZY LOGIC

system built into the appliance by switching off the unit

for two hours in every 24 hours. The frost will melt and

the defrost water will run through the drain tube from

the drip channel into an evaporating vessel located at

the bottom rear of the refrigerator (Fig 5.). The defrost

water will evaporate automatically into the circulating

air and the vessel will not need emptying manually.

To switch off the unit, turn the thermostat knob to "0",

disconnect the refrigerator from the electricity supply

and leave the cabinet door open. After defrosting the

cabinet interior should be wiped out with a clean,

damp cloth.

Figure 5.

8. Changing the lightbulb (If available)

If the lightbulb needs changing, pull out the plug and

proceed as follows:

Press the metal reflector to one side and draw the

lamp covering backwards. Replace the bulb and push

the covering back into place.

A new 10-watt bulb can be obtained at any service

shop.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Dometic EA3120 User Manual Page 6

Comments to this Manuals

Related products and manuals for Unknown Dometic EA3120