Dometic Elite RM7732 User Manual download pdf (Page 10)

B. GAS MODE

When operating in the GAS mode, the AUTO mode

indicator lamp (B) will be off and the GAS mode indica-

tor lamp (C) will be illuminated. This mode provides LP

gas operation only. The control system will activate the

ignition system and will attempt to light the burner for a

period of approximately 45 seconds. If unsuccessful,

the CHECK indicator lamp (D) will illuminate and the

GAS mode indicator lamp (C) will turn off.

To restart GAS operation, press the main power ON/

OFF button (1) to the OFF and then ON position. The

control system will attempt a new 45 second ignition

sequence.

If the refrigerator has not been used for a long time or

the LP tanks have just been refilled, air may be trapped

in the supply lines. To purge the air from the lines may

require resetting the main power ON/OFF button (1)

three or four times. If repeated attempts fail to start the

LP gas operation, check to make sure that the LP gas

supply tanks are not empty and all manual shutoff

valves in the lines are open. If the problem is still not

corrected, contact a service center for assistance.

If the control is switched to AC operation while the

CHECK indicator lamp is on, it will function properly, but

the CHECK indicator lamp will not go off until the main

power ON/OFF button is pressed to the OFF then ON

position.

C. STANDBY MODE OF OPERATION

This control system contains a feature where it will

continue to operate the cooling system in the event of a

failure of a major operating component. Two different

modes of operation can occur in this category.

If for some reason the display module becomes non-

functional, the control system will revert to full automatic

operation selecting the best energy source available

with AC as first priority, and GAS as the second priority.

The temperature of the refrigerator will be maintained at

the MID position within normal temperature tolerances.

The power module will continually attempt to

re-establish operation of the display module.

The second standby mode of operation will execute

when a failure of the temperature sensing device or

associated electronic circuitry occurs. If this should

occur, the control system will operate on the energy

source selected via the control panel. The cooling unit

will run continuously on the selected energy source. The

refrigerator will continue to operate in this mode indefi-

nitely or until a new sensor is installed and the system is

reset.

5.5.

HOHO

W W

O USE O USE

O USE

THE REFRIGERATHE REFRIGERA

THE REFRIGERA

OROR

A.A.

FOOD STORAGE COMPARTMENTFOOD STORAGE COMPARTMENT

FOOD STORAGE COMPARTMENT

The food storage compartment is completely closed and

unventilated, which is necessary to maintain the required

low temperature for food storage. Consequently, foods

having a strong odor or those that absorb odors easily

should be covered. Vegetables, salads, etc. should be

covered to retain their crispness. The coldest positions in

the refrigerator are under the cooling fins and at the bottom

of the refrigerator. The warmer areas are on the upper door

shelves. This should be considered when placing different

types of food in the refrigerator.

B.B.

FROZEN FOOD STORAGEFROZEN FOOD STORAGE

FROZEN FOOD STORAGE

COMPARTMENTCOMPARTMENT

COMPARTMENT

Quick frozen soft fruits and ice cream should be placed in

the coldest part of the compartment which is on or just

below the freezer shelf. Frozen vegetables, may be stored

in any part of the compartment.

This compartment is not designed for deep or quick

freezing of food. Meat or fish, whether raw or prepared,

can be stored in the frozen food storage compartment

provided they are precooled first in the refrigerator. They

can be stored about three times longer in the frozen food

compartment as compared to the fresh food compartment.

To prevent food from drying out, keep it in covered dishes,

containers, plastic bags or wrapped in aluminum foil.

C.C.

ICE MAKINGICE MAKING

ICE MAKING

Ice cubes can be made in the ice tray placed in the freezer

compartment. The tray should be filled with water to within

1/4" (5mm) from the top. For faster ice making, the tray

should be placed in direct contact with the freezer shelf.

To release the ice cubes, seize the tray with both hands

and twist the tray. Cubes not required should be replaced

in the tray. Refill the tray with water and replace the tray on

the freezer shelf.

Ice will be made more rapidly if the thermostat is set at its

highest position. It is a good idea to do this a few hours

before the anticipated need for ice, but be sure to move the

thermostat back to normal setting, usually about mid-

setting when the ice is formed. Food in the lower compart-

ment may be frozen if the setting is left on "COLDEST"

position.

D.D.

DEFROSTINGDEFROSTING

DEFROSTING

Shut off the refrigerator by pressing the main power ON/

OFF button to the UP (OFF) position. Empty the refrigera-

tor, leaving the drip tray under the finned evaporator, and

the cabinet and freezer doors open. Defrosting time can be

reduced by filling the ice tray with hot water and placing it

on the freezer shelf.

1 2 ... 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Dometic Elite RM7732 User Manual Page 10

Comments to this Manuals

Related products and manuals for Refrigerators Dometic Elite RM7732