Dometic 8812 Instruction Manual download pdf (Page 11)

11

iNsTAllATiON – TOileT COMpONeNTs (cont’d)

tOOls reQuireD

• Hole saws – 1” (25 mm), 1.25” (32 mm),

2” (51 mm), 2.25” (57 mm) diameters

• Drill bit – 3/16” (4.8 mm)

1

2

3

4

8

5

6

7

thrOugh-the-FlOOr cOnnectiOns

• Phillips head screwdriver

• 3/8” (10 mm) socket wrench

Place template in desired

location.

Center-punch holes and

mounting bracket corners.

Drill hole centers as shown on

template. Do not drill mount-

ing bracket corners.

With long hex-head screws

from toilet oor bracket kit,

fasten oor brackets with 3/8”

(10 mm) socket wrench using

corner marks as guides.

NOTE: Do not completely

tighten hex-head screws

to oor – allow brackets to

slightly slide. Brackets will

tighten when fastening toilet

to brackets (see step 14).

Plan locations of touchpad

panel and electronic control

module and optional acces-

sories so that all electrical

connections can be made.

Be sure module and wires

cannot get wet.

Mount electronic control

module in cool, dry place.

Drill 2.25” (57 mm) hole for

touchpad panel.

Fasten touchpad bracket and

gasket to wall, making sure

mounting tabs are at top and

bottom.

Route ribbon cable into wall

and snap touchpad panel onto

bracket mounting tabs.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

Comments to this Manuals

No comments