Dometic CABIN COMFORT Operations Instructions Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
10
Electrical
Prior to making any decisions concerning the electrical source, please refer to your specifications
sheet on your boat and note the total amperage draw to operate the necessary air conditioning
system. With this information at hand, now consider the following possibilities:
1. Generally speaking most boats come standard with a single 30 amp shore line connection.
2. Unless the boat is equipped with such electrical items that require substantial electrical
supply (such as electric stove, water heater, refrigerator/freezer, etc...) the air conditioning
system may be wired to this existing 30 amp, 115 volt service, as long as the total
requirement does not exceed 30 amp. In such cases where there are these accessories that
draw high amperage, it is recommended that an additional 30 amp shore line service be
installed to handle the additional electrical load that the air conditioning system will
require.
All Cabin Comfort Series units are supplied with a 5 position terminal strip mounted on top of
the electrical box. The electrical supply, ground wires, and pump circuits are all connected at
this terminal strip. Electrical supply to the unit is connected to the terminals marked POWER
(115 or 230 Volt). The wiring from the seawater pump is connected to the terminals marked
PUMP.
NOTE: If you use two or more units on the same seawater pump, the pump wires will be
connected to the pump relay panel to energize the pump. You will need another source of 115 or
230 volt power to run the pump. The pump relay panel should have its own circuit breaker.
Please see the wiring diagram furnished with the relay panel in this instance.
Note: Field wiring must comply with ABYC electrical codes. Power to the unit must be
within the operating voltage range indicated on the nameplate. Properly sized fuses or
HACR circuit breakers must be installed for branch circuit protection. See equipment
rating plate for maximum size.
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments