Dometic RH131D User Manual download pdf (Page 5)

3. Cleaning

Clean the refrigerator thoroughly at intervals, as

necessary. Remove the shelves; these, the

cabinet interior and the door should be washed with a

warm solution of sodium bi-carbonate. Finally wipe

over with a cloth rinsed in warm water only, and dry

with a clean cloth. Do not wash any plastic parts in

water that is more than hand warm, and do not expose

them to dry heat. The outside of the cabinet should be

wiped down regularly with a clean, damp cloth.

NEVER USE STRONG CHEMICALS OR ABRASIVE

CLEANING MATERIALS ON ANY PART OF THE

CABINET.

4. Positioning the appliance

When first using this refrigerator please consider the

following points:

ENSURE REFRIGERATOR IS LEVEL

THE PIPEWORK AT THE BACK GETS HOT IN USE

THE REFRIGERATOR HAS NO 'MOTOR' AND IS

THEREFORE VIRTUALLY SILENT

ALLOW AT LEAST 3 HRS. FOR SIGNS OF

COOLING

During the refrigeration process, the appliance

gives off heat from the condenser (under the

upper part of the rear cover) into the surrounding air.

The more ventilated the condenser is, the more

effective the refrigeration will be.

The other condition for satisfactory operation is that

the appliance is levelled. This could be checked by

placing a glass of water on top of the appliance.

It is important that the appliance is not directly

exposed to radiated heat (sunlight, radiator, near an

oven, etc.).

4.1. Installation instructions

The refrigerator is equipped with an electrically heated

absorption cooling unit which is virtually silent in

operation. The fridge is designed for free-standing

installation, but can be built-in if the following

conditions are complied with to ensure satisfactory

operation and maximum cooling efficiency.

IMPORTANT

Please follow the installation details below

carefully Guarantee is valid for products installed

as described only.

1. The refrigerator must be le

vel both directions

2. There should be 20 mm clear

ance to the w

all

3. Ventilation must be provided as shown in

alternatives A, B, C or D (fig 2-3)

4. The ventilation duct must at least measure

105 mm x the width of the refrigerator

5. Only

the entire cooling unit must project into

the duct as shown

6. Air passing thr

ough the duct must not be

preheated by any source of heat

7. Ventilation grills, if used, must have an free

openings of at leas

t 200 cm² each

The refrigerator can be fixed to the bottom of the

furniture through its fixing feet using screws of an

appropiate length. (Fig. 4)

During installation, please ensure the mains

plug is accessible at all times.

Figure 2.

Figure 3.

Figure 4.

1 2 3 4 5 6 7 8 9 10 ... 55 56

Comments to this Manuals

No comments

Dometic RH131D User Manual Page 5

Comments to this Manuals

Related products and manuals for Unknown Dometic RH131D