Dometic VGLP User Manual download pdf

Before installing the vacuum generator,

you must consider the following:

1. Vacuum generator must be mounted

horizontally only.

2. The vacuum generator can be mount-

ed up to 50 feet (15.2 m) from the

VacuFlush toilet, and 20 feet (6.1 m)

from the holding tank.

3. The vacuum generator inlet must not

be mounted more than 6 feet (1.8 m)

higher than the toilet discharge outlet.

4. The maximum head pressure on the

discharge of the vacuum generator

must not exceed 6 feet.

Note: Two-toilet systems require a

vacuum generator for each toilet (except

for some electrically operated toilet

installations.

INSTALLING THE VACUUM GENERATOR

1. Make sure the vacuum generator is properly located before proceeding. Place the vacuum generator on the

surface to be mounted. Position as needed. Using a center punch, mark the four slotted holes in the pump

feet. Remove vacuum generator.

2. Using a 3/16-inch drill bit, drill the four mounting holes. Use #14 wood screws and washers to secure vacuum

generator.

3. Position pump body to accommodate plumbing layout, if necessary, by loosening four fasteners that hold pump

onto vacuum tank, rotating pump body to desired position, and retightening fasteners.

4. Spin-nutconnectionsoninletandoutletttingsalloweasyinstallationandpositioningofhoses.Afterposition-

inginletttinginproperdirectiontoacceptinlethosefromtoilet,tighten spin-nut 1/2-turn past hand tight

with wrench. Use two hose clamps for each hose connection.

Dimensional

Specications

J-Series Vacuum Generator Components

Electrical

Specications

J-Series Vacuum Generator

Installation Instructions

Dometic Sanitation Corporation

13128 State Rt. 226, P.O. Box 38

BigPrairie,OH44611-0038USA

330-496-3211

1-800-321-9886 • Fax: 330-496-3097

® Registered; ™ Trademark of Dometic Corporation

VACUUM

SWITCH

VACUUM

TANK

INLET FITTING

OUTLET

FITTING

PUMP MOTOR

VACUUM

PUMP BODY

Model Volts (DC) Power Draw GPM (LPM) Fuse/Breaker Wire Size Lbs. (Kg)

VG412 12 6 amp (avg.) 5.1 (19.3) 10 amp

followABYC

recommendations

15.1 (6.9)

VG424 24 3 amp (avg.) 5.1 (19.3) 5 amp 15.1 (6.9)

ATTENTION:Tighteninletttingspin-nut

1/2-turn past hand tight with wrench.

1 2

Summary of Contents

Page 1 - Installation Instructions

Before installing the vacuum generator, you must consider the following:1. Vacuum generator must be mounted horizontally only.2. The vacuum generat

Page 2

WIRINGWire the vacuum generator as shown in the wiring diagram. Use multistranded copper wire. Protect the wiring by installing grommets or other prot

Comments to this Manuals

No comments

Dometic VGLP User Manual

Browse online or download User Manual for Unknown Dometic VGLP. Dometic VG4 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Dometic VGLP