Dometic EA0610 User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
7
remove the two upper left-hand screws and detach
the covering plate by pulling it forward
detach the upper hinge and mount it on the
opposite side
remove the hinge bolt and screw it in from below
insert the covering plate in the upper right-hand
corner by pushing it in and secure it with the two
screws
position the door on the upper hinge bolt and
mount the lower hinge
ensure the door can move freely and the seal is
correctly positioned.
11. Replacing the decorative door
panel, (Fig. 9-11)
Remove the two screws (1) from the upper hinge of
the door.
Pull the door together with the hinge away from the
housing and up off the lower hinge bolt (2-3).
Remove screws (4) and pull off the frame edge (5).
Slide the decorative panel (6) out of the door frame
and insert the new panel (7), so that the upper edge
of the panel runs exactly parallel to the upper edge of
the frame. A new panel can be inserted more easily
into the upper edge of the frame when the two corners
are cut off by approx. 5 x 5mm (8). Put the frame edge
(5) back in place and secure with screws.
Place the door on the lower hinge (9), slot the upper
hinge into the opening, press together with the door
against the housing and secure with the two screws (11).
13. Assembly of door handle (Fig. 12)
14. Customer service
Before you call a service engineer, carry out the
following simple tests:
Is there a power failure? Check the fuses.
Is the plug firmly connected to the socket and is
the socket switched on? Check the socket by
plugging in another appliance, e.g. a table lamp.
Is the thermostat at the correct setting?
(normally 3 or 4).
Has the door not been closed properly causing
the inside temperature to rise too quickly?
Is the refrigerator level?
Has the defrosting button been inadvertently
pushed in? (only for semi-automatic defrost)
If , so turn the thermostat dial to "0" and the
defrosting button will be released. Reset the dial
to its usual position and the refrigerator should
start cool again.
Figure 9.
Figure 10.
Figure 11.
Figure 12.
Figure 8.
Page view 6
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments