3
There are no restrictions on electrical operation.
Site of operation must be protected from rain and other water sources.
3. Storage of gas cylinders
Liquid gas cylinders should never be stored in unventilated areas or below
ground (funnel-shaped holes). Avoid direct sunlight. The gas cylinder should
not be exposed to temperatures in excess of 50°C.
4. Installation
To be installed horizontally on a smooth, firm or any other appropriate
surface. If necessary, adjust/align using a spirit level or a water-filled vessel.
There should be a distance of at least 10cm between the back of the unit
and any other object (wall).
Avoid placing unit in direct sunlight and next to other sources of heat.
For good air circulation the air vents on the top and under sides, as well as
at the back of the cooling unit must not be obstructed.
This will result in a good, energy-saving cooling system.
5. Cleaning
Prior to initial use and later after defrosting, or prior to a prolonged period
out of operation, clean the container and lid with luke-warm water and, if
necessary, washing-up liquid. Warning: do not inadvertently press or
force the opened door past its stop-point (this could cause the hinges
to break). Never use scouring or corrosive agents to clean the unit.
Wipe cleaned surfaces dry with a soft cloth.
6. A/C operation
Do not use any additional form of energy (batteries/gas).
Check that the supply voltage corresponds with the line-voltage data on the
type-plate (see back of unit).
WARNING - THIS APPLIANCE MUST BE EARTHED!
To turn on (Fig. 1)
Turn thermostat knob (A) clockwise to position 7/MAX. Only after
approximately 1 hour will the unit become noticably cool (frost on
evaporator).
The temperature can be regulated using the thermostat knob: '0'=off, 1-
7 increasing degrees of coolness.
Comments to this Manuals