Dometic RM1350 User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
- 7 -
INSTALLATION INSTRUCTIONS
SECURING THE REFRIGERATOR
It is important to follow the sequence in securing refrigerator
in enclosure since failure in doing so can cause leakage be-
tween the frame and cabinet. Any space between the counter,
storage area or ceiling and top of the refrigerator greater
than 1-1/2 inches should be blocked. The heat produced at
the rear of the refrigerator will become trapped in this space,
making the top of the refrigerator hot and reduce the ef-
ficiency of the refrigerator.
After the refrigerator is put in place (ensuring a combustion
seal at the front frame), the refrigerator is to be secured in
the enclosure with six screws (not included).
INSTALL THE SIX SCREWS IN THE FOLLOWING
ORDER:
Two screws installed through the front base.
(Installation of the lower front strip.)
The refrigerator is provided with a lower front
strip (shipped as a loose part). Attach the front
strip after the refrigerator is set into the cutout
opening.
Install the lower front strip by sliding it under
the bottom hinge plates.
Secure the refrigerator and the lower front
strip with two screws - one screw through each
hinge.
Two screws installed in he top frame.
Open the doors and fasten the refrigerator with
two screws through the holes underneath the top
decoration panel.
1.
a)
b)
2.
INSTALLING THE DRAIN WATER HOSE
TO INSTALL THE DRAIN WATER HOSE, FOLLOW
THESE STEPS:
Drill a hole through flooring. It is essential that it is
drilled in the cut out opening of the base plate at the
rear of the refrigerator.
Make sure that the hose does not kink when run
through the floor.
Seal around the hose that goes through the drilled
hole. If a longer hose than supplied is required, the
installer needs to supply one in order for the water to
drain outside of the vehicle.
1.
2.
3.
Cut out opening for
drain water hose
Ice maker
cord (optional)
Ice maker
cord (optional)
Two screws installed in the rear base.
3.
General view. Features may vary according to model.
General view. Features may vary according to model.
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments