Dometic RH131D User Manual download pdf (Page 7)

12. Changing the feet (Fig. 11)

(If available)

Should you wish to install your miniCool, you will

not need the 40-mm feet. After having removed the

40-mm feet, you can then re-attach the 12-mm

feet, located inside the 40-mm feet, to the front and

rear fixing points. The 40-mm feet and the 4

remaining screws should be retained for future use.

10. Reversing the door hang, (Fig. 7)

Lay the appliance on its back. Remove the 8 screws

(1). Remove the door, together with the two hinges

(2), from the housing.

Remove the two cover caps (3) from the housing and

place them in the open hinge holes in the housing.

Place the bottom righthand hinge in the top left of the

door and the top righthand hinge in the bottom left of

the door and hang the door on its hinges in the open

cover cap holes in the housing. Secure the hinges

and cover caps with the 8 screws.

Check that the door closes easily and is sealed

properly.

11. Replacing the decorative

door panel, (Fig. 8-10)

Remove the two screws (1) from the upper hinge of

the door.

Pull the door together with the hinge away from the

housing and up off the lower hinge bolt (2-3).

Remove screws (4) and pull off the frame edge (5).

Slide the decorative panel (6) out of the door frame

and insert the new panel (7), so that the upper edge

of the panel runs exactly parallel to the upper edge of

the frame. A new panel can be inserted more easily

into the upper edge of the frame when the two corners

are cut off by approx. 5 x 5mm (8). Put the frame edge

(5) back in place and secure with screws.

Place the door on the lower hinge (9), slot the upper

hinge into the opening, press together with the door

against the housing and secure with the two screws

(11).

Figure8.

Figure 9.

Figure10.

Figure 11.

Figure 7.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Dometic RH131D User Manual Page 7

Comments to this Manuals

Related products and manuals for Unknown Dometic RH131D