Dometic RH161LD User Manual download pdf (Page 5)

2. There should be 20 mm clearance to

the wall

3. Ventilation must be provided as shown in

alternatives A, B, C or D (fig 2-3)

Figure 3.

4. The ventilation duct must at least measure 105

mm x the width of the refrigerator

5. Only

the entire cooling unit must project into the

duct as shown

6. Air passing thr

ough the duct mus

t not be

preheated by any source of heat

7. Ventilation grills, if used, must have an free

openings of at leas

t 200 cm

each

The refrigerator can be fixed to the bottom of the

furniture through its fixing feet using screws of an

appropiate length. (Fig. 4)

Figure 4.

During installation, please ensure the mains plug is

accessible at all times.

5. Using the appliance

To start the refrigerator connect the plug to the socket

outlet and switch on the socket. The cooling fins should

show signs of cooling after about 3 hours.

The refrigerator needs about 6 hours at normal ambient

temperature to reach 6 °C in the storage compartment.

5.1. Temperature regulation

The usual setting required is in middle of the setting

range on the thermostat knob (Fig. 5), but this can vary

with conditions of load and installation. If it is found

necessary to change the setting,the knob can be turned

to a higher number to give a lower temperature, or a

lower number to give a higher temperature. The effect of

any adjustment can be checked by means of a

3. Cleaning

Clean the refrigerator thoroughly at intervals, as

necessary. Remove the shelves; these, parts, as well

as the cabinet interior and the door should be washed with

a warm solution of sodium bi-carbonate. Finally wipe over

with a cloth rinsed in warm water only, and dry with a clean

cloth. Do not wash any plastic parts in water that is more

than hand warm, and do not expose them to dry heat. The

outside of the cabinet should be wiped down regularly with

a clean, damp cloth.

NEVER USE STRONG CHEMICALS OR ABRASIVE

CLEANING MATERIALS ON ANY PART OF THE CABINET.

4. Positioning the appliance

When first using this refrigerator please consider the

following points:

ENSURE REFRIGERATOR IS LEVEL

THE PIPEWORK AT THE BACK GETS HOT IN USE

THE REFRIGERATOR HAS NO 'MOTOR' AND IS

THEREFORE VIRTUALLY SILENT

ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING

During the refrigeration process, the appliance gives

off heat from the condenser (under the upper part of

the rear cover) into the surrounding air. The more ventilated

the condenser is, the more effective the refrigeration will be.

The other condition for satisfactory operation is that the

appliance is levelled. This could be checked by placing

a glass of water on top of the appliance.

It is important that the appliance is not directly exposed

to radiated heat (sunlight, radiator, near an oven, etc.).

4.1. Installation instructions

The refrigerator is equipped with an electrically heated

absorption cooling unit which is virtually silent in operation.

The fridge is designed for free-standing installation, but can be

built-in if the following conditions are complied with to ensure

satisfactory operation and maximum cooling efficiency.

IMPORTANT

Please follow the installation details below carefully.

Guarantee is valid for products installed as described

only.

1. The refrigerator must be le

vel both directions

Figure 2.

1 2 3 4 5 6 7 8 9 10 ... 51 52

Comments to this Manuals

No comments

Dometic RH161LD User Manual Page 5

Comments to this Manuals

Related products and manuals for Unknown Dometic RH161LD