Dometic RM2410 User Manual download pdf (Page 4)

- 4 -

This appliance is certied under the latest edition of ANSI Z21.19•CSA 1.4 Refrigerators using gas fuel. The installation must

conform with local codes, or in absence of local codes, the following standards as applicable.

CERTIFICATION AND CODE REQUIREMENTS

In the U.S. the installation must conform with:

National Fuel Gas Code, ANSI Z223.1/NFPA 54 (latest edi-

tion).

Recreational Vehicles Code, ANSI A119.2 (latest edition)

Manufactured Home Construction and Safety Standard, Title

24 CFR, Part 3280.

If an external electrical source is utilized, the refrigerator, when

installed, must be electrically grounded in accordance with lo-

cal codes or, in the absence of local codes, the National Electri-

cal Code, ANSI/NFPA 70 - (latest edition).

•

In CANADA, the installation must conform with:

Natural Gas and Propane Installation Code, CSA B149.1

CSA Z240 RV Series, Recreational Vehicles.

Current CSA Z240.4, Gas-equipped Recreational Vehicles

and Mobile Housing.

If an external electrical source is utilized, the refrigerator,

when installed, must be electrically grounded in accordance

with local codes or, in the absence of local codes, the Canadian

Electrical Code, CSA C22.1, Parts I and II - (latest edition).

•

VENTILATION HEIGHTS

Minimum ventilation heights

Installation with roof vent and lower side vent

RM2410 34 inches 864 mm

RM2510 42 inches 1067 mm

Minimum

ventilation

height

Condenser

The upper vent should be centered

over the condenser coil at the back of

the refrigerator.

INSTALLATION INSTRUCTIONS

VENTILATION REQUIREMENTS

Ventilation is one of the requirements for proper cooling unit

operation. The installation should be made in such a manner as

to separate the combustion system from the living space of the

mobile home or recreational vehicle. Openings for air supply

or for venting of combustion products should have a minimum

dimension of not less than 1/4 inch.

Proper installation requires one lower fresh air intake and one

upper exhaust vent. Certied installations require one roof vent

and one lower side vent. The ventilation kits shown in this

manual have been certied for use with RM410 and RM2510.

The table below displays the components and their part no.

* Replace “XXX” with the color code numbers. For color codes,

contact your supplier. For further information, contact your dealer or

distributor.

The ventilation kits must be installed and used without modi-

cation! An opening toward the outside at oor level in the

refrigerator compartment has be provided for ventilation of

heavier-than-air fuel gases. The lower vent of the recommended

kits is provided with proper size openings. The ow of combus-

tion and ventilating air must not be obstructed.

The lower side vent is tted with a panel, which provides an

adequate access opening for ready serviceability of the burner

and control manifold of the refrigerator. This should be cen-

tered on the back of the refrigerator.

NOTE!

While washing the RV - do not spray any water

through the refrigerator vents.

Certied vent system kits

Kit no. Components Part no.

3A Roof Base

Roof Cover

Lower Side Vent

3103633.XXX*

3103634.XXX*

3109350.XXX*

1 2 3 4 5 6 7 8 9 ... 23 24

Comments to this Manuals

No comments

Dometic RM2410 User Manual Page 4

Comments to this Manuals

Related products and manuals for Unknown Dometic RM2410