Dometic RMT7650L User Manual download pdf (Page 11)

If gas faults occur the operating LED “C”

flashes

yellow.

Remedies:

Set the energy selector switch “A” to position “OFF”.

1. Is there any gas in the gas bottle?

2. Is the gas bottle valve open?

3. Is the on-board shut-off valve open?

If point 1 to 3 is

proceed with point 4 .

4. Set the energy selector switch “A” to position “AUTO” again.

The ignition starts once more.

If after about 30 seconds the operating display (C) starts flashing

yellow

again, the gas fault has not been cleared (e.g. air in the gas pipe).

5. Briefly set the energy selector switch “A” to position “OFF” and back again to

position “AUTO”!

To remove air from the gas pipes, repeat this procedure 3-4 times.

If these actions do not help, please call an authorised Dometic Service

Centre.

Frame heating

Additional functions (RMT 7655, RMT 7855)

5.2.4

Gas faults (

MES

and

AES

)

 Temperature setting display (D) with 4 LED to

indicate the selected temperature (MIN - MAX).

 LED - dimmer (E) for adjusting the brightness of

the display-LED.

(only accessible when door opens)

Underneath the fascia is a knurled knob for

adjusting the brightness (see item E above).

All models are equipped with a frame heating

(12VDC/3,5W) around the freezer compartment. During

summer months with high temperatures and humidity the

metal frame may have water droplets forming. To evapo-

rate these droplets switch on the frame heating with

switch (A). The LED (B) indicates that the heating is on.

The frame heating will draw 12V DC power continuously.

Observe LED (B) when the engine is shut off while parking the vehicle.

Shut off the frame heating.

5.2.5

5.2.6

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments

Dometic RMT7650L User Manual Page 11

Comments to this Manuals

Related products and manuals for Fridge-freezers Dometic RMT7650L