Dometic RMT7650L User Manual Page 27

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 26
27
Installation recess
The refrigerator must be installed draught-free in a recess (see “8.2”).
The measurements of the recess are given in the table below.
Push the appliance far enough into the recess until the front edge of the refrigerator
casing is flush with the front of the recess. Allow a gap of 10-20 mm between the back
wall of the recess and the refrigeration unit. The floor of the recess must be level,
allowing the appliance to be pushed easily into its correct position. The floor must be
substantial enough to bear the weight of the appliance (no hollow space
underneath).
Ensure that the refrigerator is installed level in the recess.
Recess measurements:
Securing the refrigerator
In the sidewalls of the refrigerator, there are four plastic sleeves with screws for secu-
ring the refrigerator. The sidewalls or rails attached for
securing the refrigerator must be designed in such a way
that the screws will remain firmly in place even when
under increased load (while the vehicle is moving).
Always insert screws through the sleeves provided;
otherwise, structural parts embedded in the foam,
such as cables, etc., may be damaged.
Once the refrigerator is in its final position, secure the
screws into the wall of the recess.
The screws must penetrate
through the sheet metal casing
of the refrigerator.
8.5
8.6
Model Height H
min
Width B Depth T
min
Stopper strips for example are affixed
in the installation bay, at the sides, at
the bottom and at the top and are fitted
with flexible sealant strips.
Affix strip to side wall.
Seal i.e.V seal.
plan view
H
T
RMT 7650 1685 mm 530 mm 510 mm
RMT 7651 1685 mm 530 mm 510 mm
RMT 7655 1685 mm 530 mm 510 mm
RMT 7850 1685 mm 530 mm 565 mm
RMT 7851 1685 mm 530 mm 565 mm
RMT 7855 1685 mm 530 mm 565 mm
Page view 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Comments to this Manuals

No comments