AES Refrigerator CONTINUITY READINGS FOR SWITCH CARD
&
HARNESS continued
Model 2802
The following is a list of checks that should be made on the switch card and harness assembly before
replacing the switch card or wiring harness. These checks are to be done with the wiring harness
REMOVED from the printed circuit board.
1. ON-OFF SWITCH
A. With the switch in the “ON” position, continuity should be indicated between the yellow
terminal on the 10 pin connector to the orange terminal on the 10 pin connector.
B. With the switch in the “OFF” position, NO should be indicated between the yellow terminal
on the 10 pin connector to the orange terminal on the 10 pin connector.
C. With the switch
in the “OFF” position, continuity should be indicated between the red
terminal on the 10 pin connector to the orange terminal on the 10 pin connector.
D. With the switch in the “ON” position, no continuity should be indicated between the red
terminal on the 10 pin connector to the orange terminal on the 10 pin connector.
2. AC/GAS FUNCTION SWITCH
A. With the AC/GAS function switch manually depressed, continuity should be indicated
between the blue terminal on the 10 pin connector to the orange terminal on the 10 pin
connector.
B. With the AC/GAS function switch NOT depressed, no continuity should be indicated
between the blue terminal on the 10 pin connector to the orange terminal on the 10 pin
connector.
3. AC/GAS FUNCTION LAMP
Measure resistance between the brown terminal on the 10 pin connector to the gray terminal
on the 10 pin connector. The proper resistance is approximately 65,000
OHMS.
4. GAS FUNCTION SWITCH
A. With the gas function switch manually depressed, continuity should be indicated between
the violet terminal on the 10 pin connector to the orange terminal on the 10 pin connector.
A-8-4
Manual Compliments of
Northwest RV Supply
Printed From
http://www.nwrvsupply.com
Comments to this Manuals