Dometic RM 2801 Service Manual download pdf (Page 66)

AES Refrigerator CONTINUITY READINGS FOR SWITCH CARD

HARNESS continued

IO. DELAY MODE LAMP AND SWITCH

A. With the mode switch manually depressed, resistance should be indicated between the brown

terminal on the

pin connector to the yellow terminal on the 7 pin connector. The proper

resistance is approximately 2 1,000 OHMS.

B. With the mode switch NOT depressed, no resistance should be indicated between the brown

terminal on the 10 pin connector to the yellow terminal on the 7 pin connector.

Il. GAS MODEL LAMP AND SWITCH

A. With the mode switch manually depressed, resistance should be indicated between the brown

terminal on the 10 pin connector to the green terminal on the 7 pin connector. The proper

resistance is approximately 21,000 OHMS.

B. With the mode switch NOT depressed, no resistance should be indicated between the brown

terminal on the 10 pin connector to the green terminal on the 7 pin connector.

12. GAS FLAME WARNING LAMP

Measure resistance between the brown terminal on the 10 pin connector to black terminal on the

10 pin connector. The proper resistance is approximately 21,000 OHM

NOTE:

In normal operation, the gas flame warning lamp will illuminate if the refrigerator fails to

light after approximately 3 minutes. This lamp, however, will illuminate within

approximately 10 seconds if the refrigerator fails to spark in the gas mode.

A-8-3

Manual Compliments of

Northwest RV Supply

Printed From

http://www.nwrvsupply.com

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 93 94

No comments

Dometic RM 2801 Service Manual Page 66