Dometic RM 2801 Service Manual download pdf (Page 86)

Bulletin

#R60/7A

continued

This refrigerator is

equipped with an Automatic

Energy Selector System.

The selection will be

made with the highest priority to 120 volts;

second priority to 12 volts from the battery if

the ignition is turned on; and with the lowest

priority to gas operation.

AES

PRE-DELIVERY CHECK FOR

MODEL RM1303 AES REFRIGERATOR

OPERATIONAL TESTS

A.

B.

C.

D.

E.

F.

G.

Have 120 volt supply available

Make sure you have a good 12 volt battery

supply.

Make sure gas valves at tank and rear of

refrigerator have been turned on.

Turn ON/OFF switch to ON (bottom right

front of refrigerator.

Set thermostat to setting above

#4

(second

knob from right).

Connect 120 volt supply.

Green indicator

light should be on.

Check boiler box to see if it is warming up.

CAUTION: This area becomes extremely

hot and can cause burns.

I.

Supply 12 volts to ignition lock terminal at

rear of refrigerator, or start engine. Flame

should go out

Remove 12 volt from ignition position. The

unit should now be in a gas delay.

This

delay should be approximately 20 minutes.

OVER-RIDE DELAY

1.

Turn ON/OFF switch from ON to OFF,

wait approximately 5 seconds and turn

back ON.

2.

The burner should re-light in approximately

15 seconds.

NOTE: FLASHING RED LIGHT: This indicates

J.

K

L.

If the above tests are performed without

fault, the AES is operating properly.

the unit tried to light on gas and

failed.

It is possible the unit had air

in the lines. Reset the controls.

Make sure the AES is wired directly to

battery with 30 amp breaker within 18

inches of battery.

H. Disconnect the 120 volt supply at rear of

refrigerator compartment.

The AES unit

should go to gas operation.

Check burner

box to see if flame is lit.

A-11-11

86

Manual Compliments of

Northwest RV Supply

Printed From

http://www.nwrvsupply.com

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 92 93 94

Comments to this Manuals

No comments